AMSOIL Ea By-Pass Oil Filters (EaBP) provide the best possible filtration protection against wear and oil degradation. Working in conjunction with the engine's full-flow oil filter, AMSOIL Ea By-Pass Filters operate by filtering oil on a "partial-flow" basis. They draw approximately 10 percent of the oil pump’s capacity at any one time and trap the extremely small, wear-causing contaminants that full-flow filters can't remove. The AMSOIL Ea By-Pass Filter typically filters all the oil in the system several times an hour, so the engine continuously receives analytically clean oil.
Higher Efficiency & Longer Lasting
AMSOIL EaBP Filters have an efficiency of 98.7 percent at two microns. At normal operating RPMs the EaBP Filter will filter all of the oil in a typical five quart sump in less than 10 minutes.
The superior construction of AMSOIL EaBP Filters provides better sealing and increased longevity along with superior corrosion resistance. AMSOIL EaBP Filters have a marine powder coated exterior; and their zinc-dichromate base plates increase rust protection. EaBP Filters have a nitrile HNBR gasket and an orange silicone anti-drain valve. The two stage pleated and layered cellulose/full synthetic media has an efficiency rating of 98.7 percent at two microns.
When used in conjunction with AMSOIL motor oil and an AMSOIL
EaO or Donaldson Endurance™ filter, the EaBP Filter should be
changed every other full-flow filter change up to 60,000 miles.
When used with other brands of motor oil or full-flow filters, the EaBP
Filter should be changed every other full-flow filter change. AMSOIL
recommends using oil analysis when extending oil drain intervals.
Increased Oil Capacity
The increased fluid system capacity and filtration
life provides improved oil cooling and ensures that
equipment constantly runs on clean oil. Engine efficiency
is increased, providing extended engine life.
AMSOIL has designed a new high-efficiency
by-pass filter element that is also a soot removal
device. AMSOIL Ea By-Pass Filters use a synthetic/cellulose sandwiched media. The inner
layer of the element is composed of a highly efficient
cellulose media covered with a full synthetic
media outer layer. According to ISO 23556 testing, these filters remove 39 percent
of soot contaminants less than one micron.
Soot removal efficiency increases approximately
10 to 14 percent when the EaBP Filter is used in conjunction with a standard full-flow filter.
By-Pass Filtration Benefits
• Dramatically Extended Drain Intervals
• Improved Oil Cooling
• Increased Filtration Capacity and Life
• Increased Fluid System Capacity
• Efficient Small Particle and Soot Removal
• Significantly Extended Engine Life
• Equipment Constantly Runs on Clean Oil
• Increased Engine Efficiency
• Remove Particles Less Than One Micron
|Type of Unit||Stock Number||Crankcase Capacityb||Applications|
|SINGLE SPIN-ON ELEMENT |
(Used with BMK21 or any DUAL REMOTE SYSTEM)
|EaBP90||up to 9
qt.||Pleasure Vehicles, Light Trucks and Smaller Commercial Applications|
|EaBP100||up to 15
|EaBP110||up to 21
DUAL SPIN-ON ELEMENT
(Used with BMK22 DUAL-GUARD)
|EaBP90||15 to 18 qt.||Large
Trucks, Construction, Farm and Industrial Equipment|
|EaBP100||15 to 30
|EaBP110||15 to 42
|SPIN-ON ELEMENT (Used with BMK30 Heavy-Duty Bypass System)||EaBP120||24 to 60 qt.||Large Trucks, Construction, Farm and Industrial Equipment|
a. Make sure to check oil level with engine oil dipstick to ensure proper level. This additional volume is an estimate and should be properly evaluated using the dipstick.
b. Filters can be used on sumps of larger capacity but may require more frequent filter replacement.
EABP90 filter shown in dual remote bypass system